Testing without disconnection

Compliant expert solutions

Recurrent tests and troubleshooting

All electrical equipment must be tested on a regular basis in accordance with the required standards. Regular maintenance of the electrical system avoids consequential damage and high repair costs. Portable and fixed installed ground detectors from Bender with their associated EDS insulation fault locator units help with quick and accurate pinpointing of faults, thus providing savings in terms of downtime and expenses.

Bender Service portal
Application Note EDS309x
Technical paper Insulation fault location - Planning and set up in the solar charging station at the University of Applied Sciences Bingen

Recommended systems for ground-fault location:

IEC 60364-7-710
Electrical installations of buildings - Part 7-710: Requirements for special installations or locations - Medical locations

IEC 60947-6-1
Low-voltage switchgear and controlgear - Part 6-1: Multiple function equipment - Transfer switching equipment

Retrofitting

Is my system still up-to-date?

Retrofitting

Even with state-of-the-art electrical engineering equipment, time can take its toll. Whether it is a decline in operational reliability, changes in statutory regulations or increasing energy costs: adapting to the latest state of the art is crucial. Get us to test your electrical systems and we will give you suggestions as to how to proceed.

Broschüre Bender Remote Assist
Application Note EDS309x
Fachbeitrag Isolationsfehlersuche - Projektieren und Einrichten

Recommended systems for ground-fault location:

IEC 60364-7-710
Electrical installations of buildings - Part 7-710: Requirements for special installations or locations - Medical locations

IEC 60947-6-1
Low-voltage switchgear and controlgear - Part 6-1: Multiple function equipment - Transfer switching equipment